[ Return to Main Page ] [ Return to Projects Index ] [Doc's Machine & TWB Store] [ Contact Us ] [ The Whiteboard Webcomic ]



Using the same eyeball calibration, I milled the newly-welded ends flat.
The angled end was drilled and tapped with two 1/4"-20 holes on a one-inch spacing.





All text, photos and graphics Copyright 1998- 2015, Doc's Machine & Airsmith Services. All Rights Reserved.
BH-209i and sundry IP Copyright the Tayler Corporation
Information contained in these pages is for reference and entertainment purposes only.  Our methods are not always the best,
quickest, safest, or even the correct ones. It's up to you to know how to use your own machines and tools.
Keep your fingers away from the spinny blades o' death and you should be all right.